Setup guide

16
PHYSICAL SETUP
EnglishTab 6, 14Tab 8, 16 Tab 7, 15 Tab 5, 13 Tab 4, 12 Tab 3, 11 Tab 2, 10
2. Plug the free end of the monitor cable into the
connector labeled A/V OUT to Monitor on the
control console.
3. Plug the power supply output cord into the control
console Power connector.
4. Plug one end of an AC power cord into the power
supply. Make sure you push the plug in as far as it
can go.
5. Plug the other end of the power cord into a live
AC (mains) power outlet.
6. Go to “Interactive setup” on page 17 and follow the
instructions to start up the system.
A/V OUT
to Monitor
Monitor
cable
Power
supply
Power supply
output cord
Control console
AC power cord
Power
00.Marley_Setup.book Page 16 Tuesday, January 10, 2012 8:47 AM