Instruction manual

IR
The TV use an RJ12 connection for IR OUT & Standby Line, and a 3.5mm mono socket for IR OUT.
RS232 CONNECTOR
DB9 female connector. This port allows external equipment to send and acknowledge commands for
control the Videospa TV. A standard RS232 cable should be used.
1
6
DB-9
Pin Signal
2 Tx
3 Rx
5 Ground
RS232 Protocol
Baud Rate: 9600 bps
Bits: 8
Parity: None
Stop Bit: 1
COMMAND SEQUENCE
A0 + F0 + 55 + FF + Code + Check-Sum. Code + Check Sum = 100 Hex
e.g. : Turn On: Code Checksum Complete Sequence
E1 1F A0 F0 55 FF E1 1F
Every valid command is acknowledged with the two string character “OK”.
Full commands are listed in Appendix A.
Pin Signal
1 N/A
2 N/A
3 N/A
4 Standby (On=5V , Standby = 0V)
5 Ground
6 IR OUT
Pin Signal
Sleeve Ground
Tip IR OUT
6 .. 1
Sleeve
Tip
RJ12 Socket IR OUT
10
EXTENDED CONNECTIONS