Specifications

General Operation
VTM-2000 Installation and Operation Handbook
3-23
Placing the Vector Display in Line Select Mode
NOTE: Vector Line Select only functions when in 1H or 2H sweep, or full screen.
Pressing the LINE SELECT button enables the vector pane to
monitor a single line of a video signal. This enables Line Select to
monitor individual areas of the entire image. To view a line in
Line Select mode:
1. Press the LINE SELECT button to place the selected vector display pane in Line
Select mode. At the bottom-center of the display, the pane displays the Line
number and Odd or Even field, as shown in Figure 3-23.
Figure 3-23. Establishing Line Select
2. Press the LINE SELECT button again to alternate between the ODD, EVEN, and
all fields.
3. Rotate the CURVED ARROW knob to select the line to be displayed.
Vector Pane Menu Selections
Pressing and holding the VEC function button selects the Vector pane menu. Use the
SETUP POSITION knobs or the UP, DOWN, ENTER, and EXIT buttons to navigate
the Pane menu.
The Vector Pane menu is described in Table 3-11.