Specifications

General Operation
VTM-2000 Installation and Operation Handbook
3-14
Figure 3-13. Establishing Line Select
2. Press the LINE SELECT button again to alternate between the ODD, EVEN, and
all fields.
3. Rotate the CURVED ARROW knob to select the line to be displayed.
Waveform Pane Menu Selections
Pressing and holding the WFM button enables the Waveform pane menu. The
Waveform Pane menu is described in Table 3-8 for analog waveform monitoring, and
Table 3-9 for SD-SDI waveform monitoring. The submenus are different for each
format.
NOTE: The component sequence selections are dynamically dependent on the SD and Composite
format selection. The component selections will only be shown when the component formats are
selected.
Table 3-8. Waveform (Analog) Menu Structure
FLT (FLAT) (Default)
LP (LOW PASS)
CHR (CHROMA)
COMPOSITE FILTER
F/LP (FLAT & LOW PASS)
CENTER WAVEFORM
Press SETUP/ENTER
WAVEFORM SETUP
Press SETUP/ENTER