Specifications

General Operation
VTM Series Installation and Operation Handbook
3-18
Waveform Pane Menu Selections
Pressing and holding the WFM or DISPLAY PANE buttons in the active waveform
pane enables the pane menu. The Waveform Pane menu is described in Table 3-7 for
analog waveform monitoring, Table 3-8 for SD-SDI waveform monitoring, and
Table 3-9 for HD-SDI waveform monitoring. The submenus are different for each
format. Table 3-7 through Table 3-9 indicate the menu items that are available
with the selected formats.
NOTE: The component sequence selections are dynamically dependent on the SD or HD format
selection. The component selections will only be shown when the component formats are selected.
Table 3-7. Waveform (Analog) Menu Structure
FLT (FLAT)
LP (LOW PASS)
CHR (CHROMA )
F/LP (FLAT & LOW PASS)
COMPOSITE FILTER
R-Y
PARADE
PARADE/OVERLAY
OVERLAY
COMPONENT
SEQUENCE
NOT AVAILABLE
CENTER WAVEFORM
ENTER
WAVEFORM SETUP
Press ENT
Table 3-8. Waveform (SD-SDI) Menu Structure
FLAT (FLT) -
LOW PASS (LP) -
COMPOSITE FILTER (for
digital formats)
CHROMA (CHR) -
FLAT -
LOW PASS -
COMPONENT FILTER
BOW (BOWTIE) -
PARADE -
PARADE/OVERLAY
OVERLAY -
CMPST (COMPOSITE) -
YcbCr -
RGB -
SD FORMAT
YRGB -
BLANK ALL -
SHOW SAV/EAV -
BLANKING
SHOW ALL -
(Table continues on next page)