Specifications

General Operation
VTM Series Installation and Operation Handbook
3-14
Figure 3-11. Establishing the Sweep Scale
NOTE: A menu selection is available to produce a 4H or 4V waveform.
In the SWEEP group, press the H button to select one of the horizontal sweep
modes. Also, press the H button to step through each component in a signal.
The Components that are utilized with the H button can be selected and
deselected in the COMPONENT SEQUENCE pane menu. When one to four
components are selected, press the H button to view 1H (1 Horizontal or 5.0 µS when
one component is shown). With one component selected, press the H button to toggle
between viewing one single component H waveform and multiple component H
waveforms (with blanking turned off two simultaneous component H waveforms are
used to view any ancillary data).
When two components are selected in the COMPONENT SEQUENCE pane menu, press
the H button to view 1H or 2H (2 Horizontal or 10.0 µS when two simultaneous
components are shown). When three components are selected in the COMPONENT
SEQUENCE pane, press the H button to view 1H or 3H (3 Horizontal or 15.0 µS when
three simultaneous components are shown). When four components are selected in the
COMPONENT SEQUENCE pane, press the H button to view 1H or 4H (4 Horizontal or
20.0 µS when four simultaneous components are shown in YRGB).
NOTE: Vertical Sweep is disabled when in R-Y mode (ACV only).
Also in the SWEEP group, press the V button to select one of the vertical
sweep modes. The Components that are utilized with the V button can be selected and
deselected in the COMPONENT SEQUENCE pane menu. A/B mode will show only
one component from the selection of R, G, or B when in 2V mode. When one to three
components are selected, press the V button to view 1V (1 Vertical when one
component is shown). With one component selected, press the V button to toggle
between viewing one single component V waveform and two multiple component V
waveforms (with blanking turned off two simultaneous component V waveforms are
used to view any ancillary data).
When two components are selected in the COMPONENT SEQUENCE pane menu,
press the V button to view 1V or 2V (two Vertical when two simultaneous components
are shown). When three components are selected in the COMPONENT SEQUENCE