Owner manual

Instructions manual - English - EN

9.1.11 Digital I/O

In the Digital I/O tab it is possible to conﬁgure the

digital channels available in Pan & Tilt. What follows is

a brief description of the conﬁgurable parameters for

each digital input.

• Alarm ID: Field used to select the desired digital

input.

• Type: It indicates the default state of the digital

input. It can be set Normally Open or Normally

Closed.

• Action: Each input can be associated with an

action. The action is activated when the contact is

in a state other than default. The available actions

are listed below:

• NONE: No action.

• SCAN: Position the pan & tilt on the selected

preset.

• PATROL: Activate the PATROL.

• AUTO-PAN: Activate AUTOPAN.

• WIPER: Activate the Wiper.

• WASHER: Activate the glass cleaning sequence.

• RELAY 1: Activate Relay 1.

• RELAY 2: Activate Relay 2.

• IR FILT: Deactivate the camera's IR Filter. If

available, it turns on the infrared illuminators.

To check correct operation of the alarms, a dot will

appear on the web page. The dot will be green

in normal conditions and red when an alarm is

detected.

Fig. 71

9.1.12 Washer

The Pan & Tilt wash pump is conﬁgured in the Washer

tab where it is possible to associate a preset to the

washing operation, set the duration of washing and

specify the wiper on/oﬀ delay.

Fig. 72