Instruction Manual

EN - English - Instructions manual
50
9.6.7 Washer Menu
The unit oers the possibility to use a wiper and to
operate a pump to clean the glass.
To congure the Washer put the lens of the camera in
front of the nozzle of the Washer.
Save a preset (XY) that identies this position; the
preset will be recalled by the pan & tilt when the
WASHER function is enabled.
From the menu, set the following parameters:
1. Enable: Enables the Washer function.
2. Nozzle preset: Enter the preset number (XY)
corresponding to the nozzle.
3. Wiper On Delay: Sets the interval between the
enabling of the pump and that of the wiper.
4. Washing length: Sets the length of the
brushing.
5. Wiper O Delay: Sets the length of the
brushing without water.
WASHER
------------------------
1>ENABLE : N
2 NOZZLE PRESET : 1
3 WIPER-ON DELAY : 5
4 WASHING DURATION : 10
5 WIPER-OFF DELAY : 5
Fig. 99
The enabling of the Washer function
reserves the use of Relay 2 to the switching
on of the pump and does not allow the
association of Relay 2 with an alarm.
9.6.8 Default Menu
1. Delete Setup: Resets all the parameters except
the Presets.
2. Delete Preset: Deletes all previously stored
presets.
DEFAULT
------------------------
1>DELETE SETUP?
2 DELETE PRESET?
Fig. 100
The above mentioned operations cause the
loss of all previously stored data (i.g. Preset,
Patrol, Autopan, Home…).
9.6.9 Info Menu
The menu is used to check the conguration of the
device and the installed rmware version.
INFO
------------------------
Address: 1
Protocol : MACRO
RS485-1:38400 N81 RX
RS485-2:38400 N81 REPEAT
FW: 0a (Apr 14 2009)
HW: 000-0000
Camera : 36x
PC: MPX1PVW0000A
SN: 109032220029
Fig. 101