Instruction Manual

EN - English - Instructions manual
8
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• To reduce the risk of ignition of hazardous
atmospheres, disconnect the equipment from the
supply circuit before opening. Keep the product
tightly closed when in operation.
• The equipment is certied for use in ambient
temperatures of -40°C to 60°C (-40°F / 140°F).
• Installation of this equipment shall be carried out
by suitably trained personnel in accordance with
the applicable code of practice IEC/EN 60079-14.
• Recapitulation of the certication marking as
detailed on drawing LABEL_DRAWING.
• The temperature of the surfaces of the device
is increased by exposure to direct sunlight. The
surface temperature class of the device was
determined only with ambient air temperature,
without taking into consideration direct sunlight.
• Choose an installation surface that is strong
enough to sustain the weight of the device, also
bearing in mind particular environmental aspects,
such as exposure to strong winds.
• Since the user is responsible for choosing the
surface to which the unit is to be anchored, we
do not supply the xing devices for attaching the
unit rmly to the particular surface. The installer is
responsible for choosing xing devices suitable for
the specic purpose on hand. Use methods and
materials capable of supporting at least 4 times the
weight of the device.
• This device is remotely controlled and may change
position at any time. It should be installed so that
no one can be hit by moving parts. It should be
installed so that moving parts cannot hit other
objects and create hazardous situations.
• Make sure that the device is rmly anchored.
• A power disconnect device must be included
in the electrical installation, and it must be very
quickly recognizable and operated if needed.
• It is only allowed to open the cover of the on-board
junction box for cabling of the device. The other
lids must be open from the manufacturer.
• Do not use power supply cables that seem worn
or old.
• For technical services, consult only and exclusively
authorized technicians.
• Before proceeding with installation check the
supplied material to make sure it corresponds
to the order specication by examining the
identication labels (4.2 Product markings, page
10).