User guide

MPEG4 Streaming Module

1 Hardware Setup

• Connect the ViX05 DVR to a router, hub or switch using a CAT5 cable

• Connect the Vi-MPEG4 module to the same router, hub or switch using a CAT5 cable

• Connect the Vi-MPEG4 module to the main monitor output of the DVR using a BNC cable.

• Power up the ViX05

• Connect the Vi-MPEG4 module to supplied power adaptor (12V regulated)

2 Vi-MPEG4 IP Module Configuration

The Vix05 and MPEG4 module require consecutive IP addresses. The default values are:

ViX05 192.168.1.50

MPEG4 192.168.1.51

If you need to change the default IP address of the Vi-MPEG4 module, download the utility “Vi-MPEG4 Finder.exe”

from the Videoswitch web site (www.videswitch.co.uk/software) . Double click on the downloaded file (Vi-MPEG4

Finder.exe) and follow these steps to locate and configure the MPEG4 module:

Step 1: Press Search to locate the module on the network. If no module is found, you may need to

temporarily disable your PC’s firewall.

Step 2: Click on the Device Name to select the module.

Step 3: Enter the required IP address for the module, the subnet mask and the ip address of the default

gateway.

Step 4: Click on Submit to configure the module.

Step 4

Step 1

Step 3

Step 2