User manual

ADPRO
®
XOa Client Software User Manual
21796_05_preliminary 55
Only live multicast
Multicast is the simultaneous supply of information to one or more computers
through only one data stream from the source. When multiple computers poll this
one stream, multiple copies will be created, but the initial upload will remain the
same. Multicast thus ensures less data traffic over the network.
The 224.0.0.0 through 239.255.255.255 address range has been assigned for
multicasting on the local LAN network.
Tick this option if you want to use the multicast protocol.
Multicast address
Enter the address to which the RMG video system has to send the multicast.
Note
Every camera should be assigned to a unique multicast
address. Everyone who has subscribed to the multicast,
can view the live images on this address, using a web
browser or an XOa client.
Multicast port
Enter the multicast port through which the RMG has to send the stream.
4.3.6 PTZ
Use PTZ Control
Tick this option if you have installed a PTZ camera.
Protocol
Choose the corresponding protocol for the IP camera you have installed.
Address
Enter the correct camera address for the IP camera you have installed. Check the
camera settings to know the camera address.
Auto-Home Expire
Time (sec)
This value indicates the time in seconds that has to expire after every PTZ action,
before the PTZ camera will move back to its home position.
If the value is left to 0, the Auto-Home feature will be disabled.
Positioning Time
(sec.)
PTZ preset positions can be selected via an input. When that input triggers the PTZ
action, the camera will move to the configured PTZ preset position, but the alarm
message of the input will be delayed until the PTZ preset positioning time has
expired. Thus no blurry images are recorded for quad images.
Drop Q during PTZ
Select this option if you want to drop the image quality during PTZ movements.
Note
When the Auto-Home Expire Time has been configured, the analytics detection will be
suppressed during PTZ movement. Only when the camera has returned to the home position,
the analytics detection will resume.
4.3.7 Recording
Continuous/Pre/Post
quality
This shows the quality that has been configured for continuous recordings and for
pre and post event recording.
Event quality
This shows the quality that has been configured for the event recording.
Always use event
quality for
continuous
recording
When you activate this option the quality settings for continuous recording will be
changed to the event quality settings (and no longer use the analytics quality
setting).