User manual
User Manual ADPRO
®
XOa Client Software
44 21796_05_preliminary
You cannot modify the port used by the Netfinder tool. Netfinder is an external tool used to program the IP
address of an I/O module and to update its software. You can find this tool on the CD/DVD delivered with the
system, or you can download it from the Xtralis Support website www.xtralissecurity.com.
Digital inputs may be inverted. Normally the input is configured as NO (normally open). If you tick the
Inverted option, the input will be configured as NC (normally closed).
Digital outputs can be configured for failsafe operation and/or watchdog operation. Fail safe operation means
that the relay is inverted: the output will be activated when idle. Watchdog operation means that the output
will be activated on communication time-out (network I/O protocol time out, to be defined via System >
Behaviour > Alarm transmission > General).
Click Save.
3.6 Connection to Presidium
You can associate video outputs from a Presidium with FastTrace 2 analogue inputs. Use coax cables to
connect the video outputs of the Presidium system to the video inputs of a FastTrace 2 video system for
further analysis and recording. It is then possible to transmit alarms from the Presidium to the RMG over the
IP network.
For hardware setup, see the FastTrace 2 Hardware Installation Manual.
The connection to a Presidium can trigger the following events on the RMG:
I0070 – [SYST] – PRESIDIUM FAULT: the Presidium reports a high temperature or general fault, or the
RMG detects an incorrect IP port.
I0071 – [SYST] – PRESIDIUM PRES. FAULT: no communication with the Presidium.
I1024 – [REAL] – CAM01: video signal is missing on camera 1 (detected by the Presidium).
I1025 – [REAL] – CAM01 CONTRAST ERROR: camera 1 lens is covered (detected by the Presidium).
I1033 – [REAL] – CAM01 PRESIDIUM DET: alarm on camera 1 (detected by the Presidium).
To set up the Presidium connection, proceed as follows:
1. Choose System > Connections > PresidiumHLI.
2. Select the Enabled check box.
3. In the Port box, type the IP port through which the Presidium can communicate with the server.
4. In the Channel configuration pane, assign the Presidium video outputs to the server inputs.