User manual

User Manual ADPRO
®
XOa Client Software
36 21796_05_preliminary
To talk back to a person on the remote site, proceed as follows:
1. In the menu at the top, click Live Video.
2. Click the desired camera view. By default the Push to talk mode will be active.
3. Click and hold the microphone button .
4. You can now start talking through the microphone that is connected to the MIC input of the computer.
When the option Full duplex mode has been ticked, the Push to talk mode will be disabled. In this case you
can activate the audio by simply clicking the microphone button. To deactivate the audio mode you need to
click the button again.
Make sure the audio output parameters are correct. Open System > Connections > Audio to modify the
settings. Mind that the audio IN option must be activated if you want to use Audio OUT.
Enter the audio server port (by default port 3000) that will be used to transmit audio from the client to the
server. Also select the desired protocol (by default UDP) that will be used to transmit the audio.
If you want to force duplex mode to allow simultaneous communication in both directions (not
recommended), tick the option Full duplex mode. The Push to Talk mode will be disabled when this option
is ticked.
Click Save.
3.4 Internal I/O Cards
OTB I/O (On The Box Inputs & Outputs):
 Internal Main I/O card (MIO) and Extension I/O card (EIO), offering 20 balanced inputs, 8 relay outputs
and control signals for either VM22A equipment (audio output switcher) or PTZ cameras (RS-485
output).
 Second set with MIO and EIO card possible to double the number of inputs to 40 and the number of
outputs to 16. This also adds an output for PTZ cameras.
The server automatically detects all connected MIO and EIO cards.
To configure the inputs and outputs in the client software, proceed as follows:
1. Choose System > Connections > I/O. The screen shows an overview of the I/O card sets.