User manual

ADPRO
®
XOa Client Software User Manual
21796_05_preliminary 33
To set up the IP camera network, proceed as follows:
1. Choose System > Maintenance > Hipi/Eth config.
If the server contains two HIPI cards, you see two cards listed. In all other cases, the list only contains
eth1.
2. Click eth1, and then click Edit.
3. Enter the IP address and subnet mask.
4. Click OK.
5. If the server contains two HIPI cards, repeat for the second card.
6. Click Save.
7. Click Yes and wait for the system to reboot.
3.2.2 Ethernet Cards
Note
If you receive error message 0080 – [SYST] – DECODER CARD ERROR, your Ethernet card is
not functioning correctly. Restart the server. If the error message persists, you need to replace
the Ethernet card.
3.2.3 HIPI Cards
Note
If you receive error message 0080 – [SYST] – DECODER CARD ERROR, your Ethernet card is
not functioning correctly. Restart the server. If the error message persists, you need to replace
the Ethernet card.
The HIPI card requires software. You can check the hardware and software versions of the card in the lower
pane of the configuration window. When you buy a new HIPI card, it comes with the latest available software
version.