User manual

User Manual ADPRO
®
XOa Client Software
32 21796_05_preliminary
Click Advanced. The following screen appears:
Parameter
Description
Default value
Data rate (bps)
This sets the baud rate of the modem.
115200
Authentication Access
Number
This number will be dialled by the 3G modem to
setup a data connection. The number depends on
the country and/or the provider.
E.g.: Vodafone in Australia uses *99***2#.
*99***1#
Initialisation string
Hayes command string to initialize the modem.
Note
The moment you choose 3G as modem type, and save, the server will automatically search for
the internal 3G connection.
To display the progress, the error 0030 – [SYST] – MODEM INIT FAILED appears on the
Status page. This error message disappears after about 45 seconds (depending on the
connection) when the server establishes the 3G connection. If the error message persists, there
is a problem with the modem USB connection or the 3G settings. If you have entered an
incorrect pin code, the error message 0030 – [SYST] – MODEM PIN INCORRECT appears.
If a 3G connection is set up successfully, but the server cannot establish a connect, then try
changing the control port on the Ethernet page. The default control port is 2000, but many
providers block it. Changing the control port to port 2001 may resolve the problem.
3.2 IP Camera Network Configuration
3.2.1 General Setup
Servers with an Intel motherboard use an additional network card to access the IP camera network: either a
HIPI card or an Ethernet card. The latest models with the MiTAC PH10LU motherboards do not require a
separate network card. The setup of the IP camera network is identical for all models.
Note
Connect the HIPI/Ethernet card to ETH1 or ETH2 of the server, not to ETH0.
The IP address of your RMG video system and the IP address of the HIPI/Ethernet card must
be in different ranges.