User manual

User Manual ADPRO
®
XOa Client Software
16 21796_05_preliminary
6. Click Internet Protocol Version 4 (TCP/IPv4), and then click Properties.
7. For ease of initial setup, change the PC’s TCP/IP settings to the following:
IP address
10.0.0.2
Subnet mask
255.255.255.0
8. Click OK to return to the Local Area Connection window.
9. Click OK to close the window.
2.3 Installing the XOa Client Software
Note
The procedure below describes how to install the XOa client software on a new system. For
upgrading your legacy FastTrace 2 server, see Field Alert #6 – Upgrading to XOa 3.
To install the XOa client software, proceed as follows:
1. Connect your PC to the server’s ETH0 port with an RJ45 network cross cable or via the network
switch/router on the ETH0 port.
Note
The illustration below shows a server with a MiTAC PH10LU motherboard. To locate the
ETH0 port on systems with Intel motherboards, see the FastTrace 2 Hardware Installation
Manual.