Operating instructions

12
Start „Trace
route” command
„Ping” command
The „ping” command is used to check the availability of a device in the network. The response comes back with
information on the time the data packets took to return from the device.
„Trace” command
The „trace” command is used to locate individual routers installed between the transmitter and the receiver. If a data
packet fails to reach a receiver, this command obtains a response listing all the routers through which it was possible
to send the data packet. The last response shows the router at which the data stream was broken off.
Response from video server
or network camera
Enter IP address
or camera name
Set
packet size
Number of
transmission packets
Expected
response in „x”
seconds
Start „ping”
command
The Zelaris AS also offers tools for such tasks as checking the devices connected to it for their function in the
network. These include:
• Pinging IP addresse
• Tracing IP addresse