Installation guide

8
9
5. Power on every LANCAM: plug every LANCAM power cord into the outlet. Make sure the NVR is set at „power on”
rst before this step.
6. Register LANCAM to the NVR:
a. Connect the NVR and one of the LANCAMs using the RS-232 cable.
b. Press the Setup button to enter the „MAIN MENU” page.
c. Select the item titled „COMMUNICATION” and press the „Enter” button to access the „COMM. SETTING” page.
d. Select the item termed „WIRELESS” and push „Enter” button twice to access the „WIRELESS SETTING” page.
e. Choose the item labeled „OPERATION” and press the „Enter” button twice to go to the „OPERATIONAL
SETTING” page.
f. Select the item titled „ESSID” and push „Enter” button twice to get into the „ESSID SETTING” page.
g. Give „ESSID” your local wireless network name, and use the „<”, „>”, „^” and „v” buttons to change the
existing letters based on your network name.
h. Press „Enter”, select „OK” and go to the „WIRELESS PAGE”.
i. Push „Enter” to access the „WIRELESS SETTING” page and go to the item termed „LANCAM SETUP”.
j. Press „Enter”, choose „RS-232” and push „Enter” again, upon which the terms „Waiting” and „SETUP OK”
will ash on at the bottom of the screen.
k. Push the „Setup” button to save the setup data.
l. When the words „WAITING” ash on and off at the bottom of the screen, and if the screen goes blank, you can
reboot the camera by unplugging the „Power” adaptor at the back of the LANCAM once to turn off the device
and plug the adaptor back into the LANCAM one more time to resume operation.
7. Go to the „IP/ACCOUNT” option on the „LANCAM SETUP” page on the NVR setup menu; choose any channel
(between 1 and 8) to set up the LANCAM IP address. Push the „Search” button on the NVR to nd all LANCAM IP
addresses and push the „Enter” button on the NVR to choose one of them to set the channel.
Repeat step 6 to set each LANCAM IP address.
NOTE: Once the LANCAM power cord is plugged into the outlet, it will scan the AP or NVR device automatically
and obtain an IP address from a DHCP server. This action will continue until a DHCP server is found.
If the LANCAM cannot nd it after two minutes, its IP address will change to static IP mode as
192.168.1.168. The user can push the DHCP DIP switch on the side of the LANCAM down and up once
to reset the static IP to dynamic IP (DHCP client).
NOTE: If the DHCP server of the NVR is activated, the default NVR IP address is set as 192.168.1.205.