Specifications

CCTV Mule Instructions
9
Operation Mode Setup
1 Video signal in one direction, 1 audio signal in the opposite direction.
Mode
4
The Mule2 is capable of transmitting audio in the reverse direction to 1 video camera signal. This mode
works especially well in an existing installation where 1 of the cameras could be converted into a tannoy
system using the VoiceOff. No additional cabling would be required to complete this setup.
Tx - Transmitter
1. Connect the video input signal into the ‘Video In’ port 1 (figure 1, 4).
2. Connect an audio output device such as the VoiceOff into ‘Video In’ port 2 (figure 1, 6) of the transmitter.
3. Connect the RG59 co-ax cable into the ‘Video Out’ port (figure 1, 5) the maximum length is 200 metres.
Rx - Receiver
1. Connect the RG59 co-ax cable from the transmitter to the ‘Video In’ port (figure 2, 6) of the receiver.
2. Connect an LCD monitor into the ‘Video Out’ port 1 (figure 2, 4) of the receiver.
3. Connect an audio input device such as microphone into the ‘Video Out’ port 2 (figure 2, 5).
New VoiceOFF - Alarm activated voice/sound warning unit, see >>>
Audio in this direction
Audio
V1
V1 in this
direction
1x RG59 co-ax cable
Mule 2 - Tx Mule 2 - Rx
12V DC12V DC
V1
Audio
Figure 9
TM