Specifications

CCTV Mule Instructions
8
Operation Mode Setup
1 Video signal and 1 audio signal.
Mode
3
The Mule2 can also send an extra audio signal down the RG59 allowing 1 camera signal and 1 audio to be
sent back to a monitor. There’s no need to add extra cable to the existing RG59 co-ax cable as all this can
be done with the Mule2. Figure 8 shows a diagram of how mode 3 is configured.
Audio
V1
V1 & Audio in
this direction
1x RG59 co-ax cable
Mule 2 - Tx Mule 2 - Rx
12V DC12V DC
V1
Audio
Figure 8
Tx - Transmitter
1. Connect the video input signal into the ‘Video In’ port 1 (figure 1, 4).
2. Connect an audio input device such as a microphone into ‘Video Out’ port 2 (figure 1, 6) of the
transmitter.
3. Connect the RG59 co-ax cable into the ‘Video Out’ port (figure 1, 5) the maximum length is 200 metres.
Rx - Receiver
1. Connect the RG59 co-ax cable from the transmitter to the ‘Video In’ port (figure 2, 6) of the receiver.
2. Connect an LCD monitor into the ‘Video Out’ port 1 (figure 2, 4) of the receiver.
3. Connect an audio output device such as the VoiceOff into the ‘Video Out’ port 2 (figure 2, 5).