Specifications

CCTV Mule Instructions
7
Tx - Transmitter
1. Connect the video input signal into the ‘Video In’ port 1 (figure 1, 4).
2. Connect an LCD monitor to the ‘Video In’ port 2 (figure 1, 6).
3. Connect the RG59 co-ax cable into the ‘Video Out’ port (figure 1, 5) the maximum length is 200 metres.
Rx - Receiver
1. Connect the RG59 co-ax cable from the transmitter to the ‘Video In’ port (figure 2, 6) of the receiver.
2. Connect an LCD monitor into the ‘Video Out’ port 1 (figure 2, 4) of the receiver.
3. Connect a video input signal like a camera into the ‘Video Out’ port 2 (figure 2, 5).
V2 in this direction
V1
V2
V1 in this
direction
1x RG59 co-ax cable
Mule 2 - Tx Mule 2 - Rx
12V DC12V DC
V1
V2
Operation Mode Setup
1 Video signal in one direction, 1 video signal in the opposite direction.
Mode
2
Mule2 can also transmit a CCTV video signal in reverse. This great feature is an added bonus where wirefree
is not an option due to site conditions such as trees and other obstacles in the way, especially useful if you
don’t have access to run any more cables. Figure 7 shows a diagram of how mode 2 is configured.
Figure 7