Specifications

CCTV Mule Instructions
6
Operation Mode Setup
2 Video signals down 1 co-ax cable
Mode
1
The Mule2 allows 2 separate video signals to be sent down 1 co-ax cable allowing 1 extra CCTV camera to
be added to an existing system. Figure 6 shows a diagram of how mode 1 is configured.
Tx - Transmitter
1. Connect your 2 video input signals into the ‘Video In’ ports 1 & 2 (figure1, 4 & 6)
2. The RG59 co-ax cable connects to the ‘Video Out’ port (figure1, 5), the maximum length for this cable
is 200 metres.
3. You can adjust brightness of the video inputs if required by turning the grub screw (figure 1, 3) with a
screwdriver clockwise and anticlockwise.
Rx - Receiver
1. The RG59 co-ax cable from the transmitter connects to the ‘Video In’ port (figure2, 6) of the mule
receiver.
2. Connect your video cables from the ‘Video Out’ ports marked 1 and 2 (figure 2, 4 & 5) to your video in
inputs on the back of your 2 LCD Monitors.
3. If you find the video quality is low when coming out of the receiver, you can use the ‘Gain’ control knob
(figure 2, 1) to fine adjust the video image. This is especially useful when transmitting over distance.
Step 5 - set up your chosen mode.
V1
V2
V1 & V2 in
this direction
1x RG59 co-ax cable
Mule 2 - Tx Mule 2 - Rx
12V DC12V DC
V1
V2
Figure 6