Specifications

CCTV Mule Instructions
5
The Mules require a 12v power supply to power the units, so you will require 2 power supplies. One for the transmitter and
one for the receiver.
The PSU for the transmitter needs to be capable of supplying 12v D.C. @ 125mA continuously. The PSU for the receiver
needs to be capable of supplying 12v D.C @ 120mA. Please ensure you use a fully regulated power supply or you risk
damaging the Mules.
The Mul
es have a green 2 Pin connector that connects power to the units, both the Tx and Rx are clearly marked with the
correct connection polarity. The red core is +12V and the black is 0v. See figures 4 and 5.
Please make sure that you check the polarity of the power supply that you are using to ensure the power is connected
correctly. Once power is applied to the Mules the power LED will light up and sta
y lit.
Powering the Units
Tx - Transmitter
Figure 4
Rx - Receiver
Figure 5
Installation
The units have wall mount fixings lugs either side for internal installation
however for external installation the Mules MUST
be installed in a suitable IP
rated enclosure such as the BOX420 (figure 3).
Figure 3
WARNING
POLARITY
SENSITIVE
Step 3 - fasten the unit to a wall
Step 4 - power the units.