User`s guide

19 VIDEOMAN
.VIDEOMAN Digital.
. RECEIVER : Choose PTZ camera . PTZ ID : Choose ID of PTZ camera
. MANUAL SETTING : Selects the serial port that the camera uses to connect to the
computer. Refer to camera manufacturer’s documentation to
set these values.
. OPEN : Open the connection to take control of PTZ camera.
. ARROW, FOCUS, ZOOM, AP, SPEED : Test each functionality.
. MENU : Bring the PTZ camera menu.(Depending on protocol it might not function.)
. TOUR : Tour the preset of camera.
. A1, A2, A3 : Test Extra feature of the PTZ camera.( Depending on protocol it might
not function.)
. 1~20 : Preset numbers. Move camera to each preset position.
. PRESET : Setup of waypoints can be done by doing the following:
1. Click “Preset” and press one of the numbered buttons.
2. Move the camera view to a desired location.
3. Click the same numbered button and the “Preset setup” again so that they are
no longer active.
. SCAN : Only available with camera that supports Auto Pan scan function.
START-Press START from the beginning position.
STOP-Press STOP at the ending position.
. SEND : Manually give Hex value and send it to the camera.
ㆍ Detection area setting
- Whole area : Detect motion at the whole area.
- Partial area : Click "Add“ and select specific area(s) to detect motion. Up to 10 partial area
selectable and delete them all by “Delete All".
- Display detected area : If selected, regions with motion activated can be tested for sensitivity.
any region with motion will show a group of red grid.