User manual

8. Video Function (PC Mode Only)
Press SOURCE to select a image input:
Doc # INS-45M26 Issue Date: 12/05/07
Revision:A Page 9 of 16
Press the FUNCTION button to bring up
the OSD Menu.
Press again to select IMAGE, then press
SELECT twice to enter submenu.
As shown, press keys to adjust selection.
Note: In remote control, press key to adjust.
(After adjustment, the monitor will store new settings)
Contrast
Permits adjustment for contrast between light and dark areas
of the picture.
Brightness
Adjusts the overall picture shade and brightness.
Tip: Use the Brightness to make details in the dark areas of
the picture to be just visible, and Contrast to brighten the
Menu Sub-Menu
Image
Brightness
Clock
Phase
H-Position
V-Position
Contrast
Color Temp
(9300/ 6500/ 5800)
Auto Adjust
Volume
Display Ratio
(16x9/ 4x3)
picture without causing video noise and foreheads to turn white.
Clock
Is used to adjust to the best picture quality. It adjusts the number of the clock pixels across
one timeline. Therefore it can affect the picture’s position and size.
Note: Improper adjustment will caused image failure.
Phase
Is used to adjust to the best picture quality. It adjusts the sampling phase across one pixel
at a time. When the phase is not adjusted properly, the picture will be unclear. Therefore
this value should be carefully adjusted.
Note: Improper adjustment will caused image failure.
H-Position
Allows adjustment for the horizontal position.
V-Position
Allows adjustment for the vertical position.
Color Temp
Adjust the screen color temperature 9300/ 6500/ 5800.
Auto Adjust
Auto detect screen detail data, such as clock and phase.
Display Ratio
Select between 16x9 or 4x3.