User manual

Doc # INS-45M104 Issue Date: 5/15/2012
Revision: A Page 5 of 16
4. Federal Communications Commission (FCC) Statement
This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that changes or modifications not expressly approved by that party responsible for
compliance could void your authority to operate the equipment.
5. Features
 Special Video Processor
 Inputs/Outputs: 1 BNC Composite Video, S-Video, 1CH Audio (RCA) & PC IN
 PIP Control Function (Only PC/Video)
 Screen protector (Anti-blur /Image auto move)
 NTSC/PAL Auto Switch
 3D De-interlace Technology
 3D Comb Filter Technology
 Automatic Color Control and Color Killer
 Luminance transient improvement (LTI), Chrominance transient improvement (CTI)
 Directional zoom engine
 Auto termination (75 Ohms)
 Built-in 2W+2W speaker
 IR remote control enabled
 VESA standard bracket 75/100mm
 Wall mount capability
This device complies with Part 15 FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received including interference
that may cause undesired performance.