Operation Manual

Viewing extra information
The DRX-601ESM has two information modes which enable you to view
extra information about the current multiplex.
Press the Info button and repeat or hold down to cycle through the two
different information modes. Press the Display button to return to normal
display mode.
Mode Displays the mode of the current service, Stereo (ST)
or Mono (MN) and the data rate at which the audio
signal is being transmitted. This rate is set by the
broadcaster to suit the type and quality of material
being transmitted.
Signal strength Displays the strength of the signal for the current
multiplex. Maximum strength is indicated by 16 bars
across the display. Note If sound quality is poor, try
repositioning your aerial whilst observing the signal
strength indicator, you may be able to increase
reception quality.
Changing the display brightness
The DRX-601ESM display has four levels of brightness which you can
alter to suit your room’s light levels.
Press the Bright button and repeat or hold down to cycle through the four
levels of brightness available.
Selecting a service
Once you have tuned your DRX-601ESM you can select the digital radio
service you want to listen to. You use the large turn-and-push knob to select
a service.
1. Rotate the large tuning knob to see the names of other stored
services on the bottom line of the display. Stop when you find the
service you want to listen to.
2. Push and release the large tuning knob to listen to the service you
have selected.
If the service you select is in stereo, the Stereo LED will light up. If the
service you select has one or more secondary services available, the
Secondary LED will light up.
See page 13 for information on primary and secondary services and see
page 12 for details on selecting primary or secondary services.
9