Operation Manual

Viewing extra information
The DRX-601E/ES has two information modes which enable you to view extra information
about the current multiplex.
Press the Info button on the front panel of your DRX-601E/ES and repeat or hold down to
cycle through the two different information modes.
Changing the display brightness
The DRX-601E/ES has four levels of brightness which you can alter to suit your room’s light
levels.
Press the Brightness button on the front panel of your DRX-601E/ES and repeat or hold down
to cycle through the four levels of brightness available.
Changing the display mode
The DRX-601E/ES display feature has four modes which enable you to view different elements
of the broadcast data on the bottom line of the display.
Press the Display button on the front panel of your DRX-601E/ES and repeat or hold down to
cycle through the four different display modes.
Dynamic Label Segment The default mode, displays scrolling text messages which
accompany the audio, where available.
Program Type A label describing the type of content being broadcast by the
service.
Multiplex name Displays the name of the Multiplex in which the current
service is found. See the Guide to Digital Radio section on
page 9 for information on Multiplexes.
Technical Information Displays the channel label and centre frequency for the
current multiplex. See the Guide to Digital Radio section on
page 9 for information on channels and digital radio
frequencies.
Signal strength Displays the strength of the signal for the current multiplex.
Maximum strength is indicated by 16 bars across the display.
Note If sound quality is poor, try repositioning your aerial whilst
observing the signal strength indicator, you may be able to
increase reception quality.
Mode Displays the mode of the current service, Stereo (ST) or
Mono (MN) and the data rate at which the audio signal is being
transmitted. This rate is set by the broadcaster to suit the type and
quality of material being transmitted.
7