User's Manual

TMX24120 Label & Location
November 6 2012
Installation is as follows:
1. First attach the 2 sided foam tape within the marked area on the PCB shown on the master build sheet. Trial
fit the radio module on the PCB and ensure it locks in place. (Adjust the PCI fingers to ensure a good fit if
needed). Release the Radio and peel off the 2
nd
protective layer of the 2 sided tape and install the RADIO
MODULE (press to make good contact with the tape).
2. Attach the SMA jumper cables to the module (follow the build sheet) using the special 8mm Wrench
installation tool. Attach the other end to where the build sheet indicates (amplifier, antenna or antennas). Follow
wiring diagram very carefully.
3. Confirm all cables are connected as indicated on your build sheet.
4. Attach the MAIN SYSTEM PCB (with the module installed) on the metal mounting plate (be careful not to
get any wires caught on the mounting studs. Put in the 3 pieces of 4-40 screws. Tighten with torque set
screwdriver until it clicks.
5. Route the antenna wires to their appropriate place indicated on the build sheet. Secure with Tie Wraps
6. (if build sheet indicates amplifier) the amplifier comes attached to a heatsink with its power supply attached
but not connected. Attach wires as indicated in the diagram. (see attached exhibits)
7. Route power wires from main PCB to the mounting plate connections. Secure any loose wiring with Tie
Wraps.
8. Install any RCA cable jumpers from the main PCB to the mounting plate. Secure any loose wires with Tie
Wraps.
9. Confirm all wiring is connected as described on the build sheet and there is no loose wiring.
10. Initial to confirm all wiring steps.
11. Install the mounting plate with attached PCB and module into the enclosure. Secure with 3 screws and
ensure they are snug only. Don’t over tighten or you will strip the plastic threads.
12. Pass the system to the test bench.