User's Manual

TMX24120 Label & Location
November 6 2012
TMX24120 MODULE INSTALLATION
INSTRUCTIONS
The TMX24120 radio will be packaged in a pink anti-static plastic bag. It is critical that it only be opened at an
ESD safe work station and the technician be properly instructed on how to handle ESD devices and be grounded
with an approved tested wrist strap.
The Module will be accompanied by a MASTER BUILD SHEET when removed from inventory and given to a
technician for assembly into a SYSTEM. The Radio MODULE will be marked externally with its SERIAL
number and this number must be copied to the master build sheet for the system. Additional Serial number
labels will also accompany the MODULE to be attached to the outside of the SYSTEM enclosure.
As the technician installing the module you must clearly indicate on the build sheet your ID number for QC
purposes.
The radio will be packaged with the following accessories to complete the installation. (This may vary with
SYSTEM model being assembled, see BUILD SHEET)
1. 1 piece of (foam center) 2 sided mounting tape to help secure the module within the MINI PCI
connector.
2. 1 set of FCC labels to be installed on the approved MODULE.
3. 1 set of FCC labels to be installed on the outside of the finished SYSTEM.
4. 1 amplifier assembly (depending on SYSTEM model).
5. Antenna or antennas configured for the SYSTEM on the build sheet.
6. 6 tie wraps to secure wiring.