User's Manual

TMX24120 Label & Location

November 6 2012

5. If the FCC ID for the TMX24120 Radio is not visible when installed in the host platform, then a permanently

attached or marked label must be displayed on the host unit referring to the enclosed radio.

For example, the label should contain wording such as:

7. All supplied antennas have been tested to comply with FCC requirements

8. The transmitter and antenna must not be co-located or operating in conjunction with any other antenna or

transmitter. Violation of this would allow a user to plug another transmitter in to the product and potentially create

an RF exposure condition.

Contains: TMX24120 Radio transmitter module

FCC ID: SU5-TMX24120 / IC : 3667A-TMX24120

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) This device must accept any interference

received, including interference that may cause undesired operation

Contains FCC ID: SU5-TMX24120

IC : 3667A-TMX24120

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

and (2) This device must accept any interference

received, including interference that may cause

undesired operation.

WARNING

The transmitter and antenna must not be colocated

or operating in conjunction with any other antenna or

transmitter. Failure to observe this warning could

produce an RF exposure condition.