User's Manual

TMX24120 Label & Location
November 6 2012
1. Turn on the server and client power supplies and verify a link is established.
2. Observe the video latency, link rate and current consumption of each system; observe the quality of the
video picture. Note your findings on the build sheet.
3. Turn off the 2 systems and disconnect the power supplies
4. Recheck all connections and confirm all loose wires are secure, all connectors (Power and RF) are snug.
Note any errors on the build sheet.
5. For the Omni Antenna versions (Rubber Duck), leave the antennas loose to be packed in the box. For IP
(internal Patch) antennas, secure the antenna to the internal mounting plate making sure the screws are
secure and SMA connectors are securely attached to its mating cable or amplifier (as per the build sheet).
6. Close the top of the enclosure and attach all necessary identification labels as indicated. Attach the
FCC labels as indicated on the back of the enclosure (See Below).
7. Wrap the front face of the enclosure with low tack protective sticky plastic.
8. Pass the system (PAIR) and any accessories to the packaging department with the serial number labels
to be placed on the outside of the box and hand in the build
sheet.
CONTAINS:
M/N: TMX24120
FCC ID: SU5 –TMX24120
IC: 3667A-TMX24120
FCC & IC Label for Exterior Placement