Owner`s manual

MXR-5838 Series Manual Rev. B 2007

Conducting a Bench Test

With so many technical variables in an installation, the strongest recommendation we can make

is to conduct a bench test. After verifying that all components of the system are in good working

order and connected properly, we can arrive on the job site confident that all of our devices will

install with the least amount of on site effort.

Basic Bench Test Procedure

1. Physical Inspection of Product

• Compare the unit to the product photo on the attached specification sheet.

• Check for physical damage to the devices, contact your distributor or VideoComm Technologies

Technical Support immediately should you suspect damage to the unit.

• Ensure all parts are included.

2. Bench Testing Your 5.8GHz device

• Ensure there are no live wires on the test bench that may cause an electrical short.

• Ensure the camera and monitor used in the bench test and on site are in good working order by

conducting a hardwired video test.

• Use a multimeter to ensure the power supplies have the proper voltage output.

• Attach the included rubber duck antennas to the receiver.

• Connect power supply leads to the camera & receiver.

• Use a separate power supply for each device. Do not share power supplies.

• Connect the Video Output from receiver to your monitor

BNC-Female RCA-Female

Not-Used

RCA-Female

Not-Used

2.1mm Barrel SM

-Female