MXR-5838 Series Manual Rev. B 2007 # EWC-003 (MXR-5838c ) # MX-5838c 5.
MXR-5838 Series Manual Rev. B 2007 TABLE OF CONTENTS TABLE OF CONTENTS ............................................................................. 2 SAFETY NOTICES...................................................................................... 2 INTRODUCTION......................................................................................... 3 PARTS LIST ................................................................................................. 4 SYSTEM SETUP .............................
MXR-5838 Series Manual Rev. B 2007 INTRODUCTION Introduction VideoComm introduces a real-time wireless camera solution that is not susceptible to interference from 2.4GHz 802.11 b/g data devices. Featuring 4 user selectable channels, this wireless camera system is an ideal choice when multiple wireless video links are required for any portable, temporary or covert surveillance and monitoring application.
MXR-5838 Series Manual Rev. B 2007 PARTS LIST This 5.8GHz wireless camera system has been carefully manufactured, tested, inspected and packaged. Please inspect the packaging carefully to ensure you have received all the necessary parts and accessories listed. Refer to the following chart to determine which parts are included with your product. If any parts are missing or damaged, contact VideoComm Technologies, Customer Service or your re-seller immediately.
MXR-5838 Series Manual Rev. B 2007 SYSTEM SETUP Channel Selection Camera For the wireless link to work, both devices must have the same channel selected. 1. 2. 3. 4. Power-UP the Camera using the included power supply & switch to “ON” Set the desired channel by moving the slide switch The receiver must be set to have the same and matching channel as the camera. Flip UP the directional antenna and pivot left or right to “aim” the transmitted signal in the direction of the receiver.
MXR-5838 Series Manual Rev.
MXR-5838 Series Manual Rev.
MXR-5838 Series Manual Rev. B 2007 Channel Selection Receiver For the wireless link to work, both devices must have the same channel selected. 1. 2. 3. 4. Attach the included rubber duck antenna to the TNC connector on receiver. Power-UP the Receiver using the included power supply & switch to “ON” Set the desired channel by turning the rotary switch to channels from 1 – 4 Receiver channels from 5 to 8 will only work with VideoComm Transmitters devices capable of 8-Channels.
MXR-5838 Series Manual Rev. B 2007 Conducting a Bench Test With so many technical variables in an installation, the strongest recommendation we can make is to conduct a bench test. After verifying that all components of the system are in good working order and connected properly, we can arrive on the job site confident that all of our devices will install with the least amount of on site effort. Basic Bench Test Procedure 1.
MXR-5838 Series Manual Rev. B 2007 TIPS & TROUBLE SHOOTING Things that block transmission Things that block transmission are not always obvious. Consider any obstruction that may get in the way or reduce the wireless signal strength along the way. Here are some of the most common pitfalls: • Transmitting through walls in an office environment may be limited if the transmitting path has many desks, computers and other office type equipment in it’s path.
MXR-5838 Series Manual Rev. B 2007 SPECIFICATIONS Camera Operating Frequency 5.725GHz – 5.875GHz, 4 User Selectable Channels Receiver Operating Frequency 5.725GHz – 5.
MXR-5838 Series Manual Rev. B 2007 WARRANTY INFORMATION/ TERMS & CONDITIONS VideoComm Technologies, herein referred to as “VCT.” LIMITED WARRANTY VCT hereby warrants, subject to the conditions here in below, that should this product become defective by reason of improper workmanship or material defect during the specified warranty period, VCT will repair the same, effecting all necessary parts without charge for either parts or labor, or replace the unit at VCT option.
