User's Manual

VideoComm Technologies
TCO-5808 All Weather 8-Channel Series
Video & Audio Connections – Receiver or Transmitter
Loosen the desired cable gland using a Metric 22mm
wrench.
(Closest Imperial Size – 7/8”)
Feed the video and audio cable through the cable gland
hole.
VideoComm Technologies recommends the use of RG-59
or higher grade coaxial cable for video and audio.
Do not use video / audio cable that is less than ¼ inch in
diameter, as this may not allow a proper seal when the
cable gland is tightened. If a tight seal is not made between
the cable gland and the video cable, there is a chance of
water leaking into the enclosure, causing serious damage.
The maximum diameter of cable that should be used in the
cable gland is ½ an inch diameter.
IMPORTANT!!! Attach BNC - male connectors to the
video and audio cables after the raw cable has been fed
through the cable gland. The BNC (M) connectors are to
large to fit through the cable gland hole. Be careful not to
damage the rubber seal inside the cable gland as you feed
through your video cable.
Attach BNC (M) connectors to the video and audio cables.
After the BNC (M) connectors have been attached to the
wire make terminations to video and audio bulkhead BNC
(F) connectors for the device.
WARNING!!! If you do not tighten the cable gland, you
do not have a watertight seal.