Installation Guide

5.8GHz All Weather 8 Channel Series Manual Rev. E
Video& Audio Cable Installation & Termination
Loosen the desired cable gland using a Metric 22mm
wrench.
(Closest Imperial Size – 7/8”)
Feed the video and audio cable through the cable
gland hole.
VideoComm Technologies recommends the use of
RG-59 or higher grade coaxial cable for video and
audio.
Do not use video / audio cable that is less than ¼
inch in diameter, as this may not allow a proper seal
when the cable gland is tightened. If a tight seal is
not made between the cable gland and the video
cable, there is a chance of water leaking into the
enclosure, causing serious damage.
The maximum diameter of cable that should be used
in the cable gland is ½ an inch diameter.
IMPORTANT!!! Attach BNC - male connectors to
the video and audio cables after the raw cable has
been fed through the cable gland. The BNC (M)
connectors are to large to fit through the cable gland
hole. Be careful not to damage the rubber seal inside
the cable gland as you feed through your video
cable.
Attach BNC (M) connectors to the video and audio
cables.
After the BNC (M) connectors have been attached to
the wire make terminations to video and audio
bulkhead BNC (F) connectors for the device.
WARNING!!! If you do not tighten the cable gland, you do not have a watertight seal.