Installation Guide

5.8GHz All Weather 8 Channel Series Manual Rev. E
Tools Required
The 5.8GHz All Weather 8 Channel Series is designed to be “Plug & Play” and simple
to install with minimal tools. The following is a list of recommended tools to setup your
system.
Coaxial Cable Stripper - For preparing video & audio coaxial cable.
Wire Stripper – For preparing alarm input and power wires.
Phillips Screw Driver – Used for unscrewing the front cover of the IP-67 enclosure to gain access to video,
audio, alarm input and power terminations.
Mini Flat Head (Slot) Screw Driver – Used for changing the receiver antennas polarization from horizontal
to vertical. ( if required )
Metric 22mm Wrench ( Closest Imperial Size – 7/8”) - Used for tightening or
loosening the three larger all weather cable glands.
Do not use pliers as they may cause damage to the cable glands
Metric 15mm Wrench (Closest Imperial Size – 5/8”) – - Used for tightening or
loosening the single small all weather cable gland.
Do not use pliers as they may cause damage to the cable glands
Hand Held LCD Monitor – Recommended for verifying video images at input
to transmitter and output from receiver. Perfect for camera angle and focus
adjustment.
Multimeter – Measures voltage output, amperage, resistance and cable continuity.
Do Not Use Pliers - the pliers rigid grip may cause damage to the cable glands and the all weather IP-67
enclosure.