Installation Guide

5.8GHz All Weather 8 Channel Series Manual Rev. E

Wall Mounting

Attach the base plate and enclosure pivot

plate of the BRK-250 bracket using two 4 x

11/32” mounting screws, one screw per

side.

Mount the base plate of the BRK-

250 to the wall using

four screws or bolts (not included). Ensure the mount is

secure and will able to support the weight of the

transmitter or receiver.

Insert the four 4 x 11/32” mounting screws into

each screw port of the all weather enclosure.

Fasten the mounting bracket to the IP-67 enclosure

by tightening the 11/32”bolts until snug. Do not

over tighten.

Replace the front cover of the transmitter or receiver. Do not over tighten the screws as this

can crack or cause damage to the front cover of the unit. Verify all cable glands are snug,

water tight seal.