Installation Guide

5.8GHz All Weather 8 Channel Series Manual Rev. E
Antenna Polarization Continued….
Changing Receiver Antenna Polarization
To change the polarization of the receiver antenna, carefully
unscrew the two nylon screws that hold the antenna to internal metal
mounting bracket. Do not to scratch or bend the antenna as this will
affect receiving performance The screws are located on the edge of
the metal RF reflector, on the left hand side.
Rotate the antenna to desired vertical or horizontal
polarization as shown in the
diagram below.
CAUTION Do not over twist the antenna cable as
damage may occur.
After positioning the antenna, carefully
re-tighten the two screws that secures the
antenna to the metal bracket.
Do not over tighten the nylon screws.
Ensure the antenna cable is securely attached to the
connector located on the strain relief of the RF reflector.