User manual

System initialise
Running selected features
Installer notes
SYSTEM INITIALISE
-----------------------------
CLEAR ALL DATA
CLR DISPLAY SET
CLR CAMERA SET
CLR MOTION SET
CLR FUNCTION SET
REBOOT CAMERA
REBOOT SYSTEM
BACK
EXIT
From the main menu, use the joystick to
highlight SYSTEM INITIALISE and key: NEAR
CLEAR ALL DATA - selecting this option will
perform a full factory reset on the speed
dome. CAUTION: this option will erase all
speed dome functions (patterns, presets etc.)
CLR DISPLAY SET - this option will reset the
on screen display settings to factory default
and erase all privacy zones.
CLR CAMERA SET - this option will reset the
camera module settings to factory default.
CLR MOTION SET - this option will reset the
motion menu settings to factory default and
erase all schedules.
CLR FUNCTION SET - this option will erase
all presets, VST functions, patterns, groups.
REBOOT CAMERA - this option will reboot
the camera module only.
REBOOT SYSTEM - this option will reboot the
entire speed dome system.
Highlight the item to modify and key: NEAR
Use the joystick to change the setting to YES
and key: NEAR to confirm or: FAR to cancel.
NO
NO
NO
NO
NO
NO
NO
Once pattern tours, groups and VST functions
have been programmed in the speed dome
setup menu, they can be accessed directly
from the VA-KBDPRO+ by using the following
sequences.
1. To start a pattern tour, key either:
X - PATTERN *or* PRESET - 13X - ENTER
Where X is a pattern tour between 1 & 4.
2. To start a VST function, key either:
X - VST *or* PRESET - 14X - ENTER
Where X is a VST number between 1 & 8.
3. To start a group, key:
X - GROUP *or* PRESET - 15X - ENTER
Where X is a group number between 1 & 8.
The selected functions will run indefinitely
until a manual movement is made by the
operator, an alarm input is received, or a
scheduled operation occurs.
4. Additional functions
Special features of the speed dome can be
called directly by using the following
sequences
Activate relay: SET - 161 - ENTER
Deactivate relay: PRESET - 161 - ENTER
Force DAY mode: PRESET - 179 - ENTER
Force NIGHT mode: PRESET - 178 - ENTER
Force AUTO mode: PRESET - 177 - ENTER
Switch OSD to auto: PRESET - 190 - ENTER
Switch OSD off: PRESET - 191 - ENTER
Switch OSD on: PRESET - 192 - ENTER
Privacy zones on: PRESET - 194 - ENTER
Privacy zones off: PRESET - 193 - ENTER
Note: the special features above can be
called by schedules so it is possible, for
example, to define the exact time of day for
DAY / NIGHT switching.
This page is left blank for any notes which may be useful once installation is complete.
13