User manual

Cabling the 5P Terminal Block Cabling the 7P Terminal Block
14 15
2
Power
3
Keyboard Controller/DVR
2
Monitor
1
BNC Video
Relay Out Input Slot Sensor/Alarm Input Slot
Sensor/Alarm Input
2
- It connects to IR sensor, IrDA sensor or door switch. If the
sensor is activated, it can activate to move camera to the
specific angle and to connect the alarm device.
- A cable of the sensor should connect to input 1 or 2, and
the other should be connected to ‘COM’ slot.
- If you want to use alarm input, the types of sensor must be
selected in OSD menu (CONCEPT PRO SPEED DOME>
MOTION SETUP>ALARM INPUT SETUP). The sensor types
are normal open and normal close.
Output voltage is high state when sensor is
activated.
Output voltage is high state when sensor is not
activated.
Normal Open
(N.O)
Normal Close
(N.C)
N.C
Activation
Activation
N.O
In 2
COM
In 2
COM
In 2
COM
In 2
COM
In 2
COM
Relay Out
1
Output voltage is high state when sensor is
activated.
Output voltage is high state when sensor is not
activated.
Normal Open
(N.O)
Normal Close
(N.C)
- It connects to the alarm lights, siren or lamps, and it is
activated according to the OSD menu setting.
- If you want to use relay out, the types of sensor must be
selected in OSD menu (CONCEPT PRO SPEED DOME>
SYSTEM SETUP>RELAY TYPE). The sensor types are normal
open and normal close.
Out Out
<Inside of terminal block: Activation type of relay out N.O.>
<Inside of terminal block: Activation type of alarm input N.O. / N.C.>
Sensor/Alarm Input
2
Relay Out
1
5P Terminal Block
5p terminal block connects the sensor/alarm input and the
relay out device to the camer’s main body. (Refer ‘Installation
Using Surface Mount Bracket’ of page 10 for the connection
of the terminal block.)
Power
3
Power Power ConsumptionRange
DC 12V 7.8WDC 11V ~ 15V
- Please check the correct rated power.
- The rated power is marked on the bottom of the camera.
Monitor
1
Connects to video output device such as monitor using the
BNC coaxial cable.
Keyboard Controller/DVR
2
Controls PTZ by connecting with keyboard controller or
DVR using RS-485 communication standards.
7P Terminal Block
7p terminal block connects the power, keyboard controller/
DVR or video device and etc to the camera’s main body.
(Refer ‘Installation Using Surface Mount Bracket’ of page 10
for the connection of the terminal block.)
Video Input Slot
RS-485 Communication Input Slot
Power Input Slot
Keyboard Controller/DVR
Camera 1 Camera 2 Camera n
~