Manual

5.3.4. Re-enabling Bluetooth
It is possible to re-enable Bluetooth using the MODE button.
To re-enable Bluetooth:
a. Depress and hold the MODE button (on the blue smart charger) for 10 seconds.
b. After 10 seconds have elapsed all blue LEDs will blink twice to indicate that Bluetooth has been re-enabled, and all Bluetooth
settings reset.
DURING THIS PROCEDURE:
a. Bluetooth is re-enabled
b. The PIN code is reset to default (000000)
c. Any active Bluetooth connections are disconnected
d. All Bluetooth pairing information is cleared
Subsequently, before attempting to re-connect it’s also necessary to remove/clear the blue smart charger
Bluetooth pairing information from any devices (mobile phones or tablets) that were previously paired.
Blue Smart IP22 Charger
Page 16 Setup