Manual

5.3.2. Resetting the PIN code
If the PIN code is forgotten or lost, it can be easily reset to the default 000000 using the VictronConnect app or the MODE button
on the charger.
Using VictronConnect
To reset the Bluetooth PIN code:
a. Locate the blue smart charger in the LOCAL page and select the ‘device options’ icon (three vertical dots) on the right side
of the description.
b. Select 'Reset PIN code' from the pop-up prompt.
c. Enter the PUK code and select ‘OK’. The PUK code is located on a label stuck to the back of the blue smart charger.
Using the MODE button
To reset the Bluetooth PIN code:
a. Depress and hold the MODE button (on the blue smart charger) for 10 seconds.
b. After 10 seconds have elapsed all blue LEDs will blink twice to indicate that the PIN code has been reset.
DURING THIS PROCEDURE:
a. The PIN code is reset to default (000000)
b. Any active Bluetooth connections are disconnected
c. All Bluetooth pairing information is cleared
Subsequently, before attempting to re-connect it’s also necessary to remove/clear the blue smart charger
Bluetooth pairing information from any devices (mobile phones or tablets) that were previously paired.
Blue Smart IP22 Charger
Page 14 Setup