Technical information

52
BLUESOLAR CHARGE CONTROLLERS
www.victronenergy.com
BlueSolar 12/24-PWM Three models: 5A, 10A or 20A at 12V or 24V *
- Low cost PWM controller.
- Internal temperature sensor.
- Three stage battery charging (bulk, absorption, float).
- Protected against over current.
- Protected against short circuit.
- Protected against reverse polarity connection of the solar panels and/or battery.
- With low voltage load disconnect output.
- Optional remote display (20A model only)
BlueSolar DUO 12/24-20 20A at 12V or 24V *
- PWM controller.
- Charges two separate batteries. For example the starter battery and the service battery of a boat or
mobile home.
- Programmable charge current ratio (standard setting: equal current to both batteries).
- Charge voltage settings for three battery types (Gel, AGM and Flooded).
- Internal temperature sensor and optional remote temperature sensor.
- Protected against over current.
- Protected against short circuit.
- Protected against reverse polarity connection of the solar panels and/or battery.
BlueSolar MPPT 12/24-40 40A at 12V or 24V *
- Maximum Power Point Tracking (MPPT) controller. Increases charge current by up to 30% compared to
a PWM controller.
- Charge voltage settings for eight battery types, plus two equalize settings.
- Remote temperature sensor.
- Protected against over current.
- Protected against short circuit.
- Protected against reverse polarity connection of the solar panels and/or battery.
- With low voltage load disconnect output.
* For 12V use 36 cells solar panels
For 24V use 72 cells solar panels
BlueSolar charge controllers
BlueSolar 12/24-10
BlueSolar MPPT 12/24-40
Starter battery
Service battery
BlueSolar DUO 12/24-20
Two remote displays:
- for BlueSolar 12/24-20
- for BlueSolar DUO 12/24-20