Datasheet

68
BlueSolar PWM charge controllers
www.victronenergy.com
BlueSolar 12/24-PWM Three models: 5A, 10A or 20A at 12V or 24V
- Low cost PWM controller.
- Internal temperature sensor.
- Three stage battery charging (bulk, absorption, float).
- Protected against over current.
- Protected against short circuit.
- Protected against reverse polarity connection of the solar panels and/or battery.
- With low voltage load disconnect output.
- Optional remote display (20A model only)
BlueSolar DUO 12/24-20 20A at 12V or 24V
- PWM controller.
- Charges two separate batteries. For example the starter battery and the service battery of a boat or
mobile home.
- Programmable charge current ratio (standard setting: equal current to both batteries).
- Charge voltage settings for three battery types (Gel, AGM and Flooded).
- Internal temperature sensor and optional remote temperature sensor.
- Protected against over current.
- Protected against short circuit.
- Protected against reverse polarity connection of the solar panels and/or battery.
BlueSolar 12/24-10 with timer 10A at 12V or 24V
- PWM solar lighting controller.
- Two timers to enable dusk to dawn operation, or limited time after dusk and limited time before
dawn operation.
- Seven segment display to visualize timer settings and analyze fault conditions.
- Battery status indicator with over discharged warning.
- Internal temperature sensor.
- Three stage battery charging (bulk, absorption, float).
- Protected against over current.
- Protected against short circuit.
- Protected against reverse polarity connection of the solar panels and/or battery.
- Low voltage load disconnect override.
PWM charge controllers
BlueSolar 12/24-10
Starter battery Service battery
BlueSolar DUO 12/24-20
Two remote displays:
- for BlueSolar 12/24-20
- for BlueSolar DUO 12/24-20
BlueSolar 12/24 with timer