User manual

GMDSS Monitor
24.7V -4.9A 94%
8 GMDSS Monitor
8.1 Quick status line
The GMDSS monitor is designed to give quick access to all relevant information, without having to scroll though abundant
information. The ‘quick status’ simultaneous displays the most important parameters; the battery voltage, the battery current
and the state-of-charge (SOC). In the root menu of the VE.Net GMDSS Panel you will see this screen
Notes:
1) You can always return to this position by pressing “Cancel” repeatedly.
2) If you can’t see the state of charge, the GMDSS monitor isn’t synchronized with the battery yet. It can take some time before
the GMDSS charger completely charges the battery.
Quick status
DC Voltage Displays the actual voltage of the battery.
DC Current Displays the DC current that flows in or out of the batteries.
State of charge The state of charge is a representation of the energy left in the battery 100% is full and 0% is
empty. This is the best way to see when the batteries need to be recharged. Note that most
battery types will be damaged if they are discharged below 50%.
8.2 Read out menu
To go to the read out menu, press “Enter” when you are looking at the quick status line. In this menu you will find the following
read outs. Notice: these read out only have a meaning in case of a charger or mains failure.
Read out menu
Consumed Ah Displays the used ampere hours since the battery was fully charged.
Time to go Displays time left before the batteries need to be recharged at the current load.
Battery voltage State of charge
Battery amps