User manual

7 The VE.Net GMDSS Panel
7.1 Using the Panel
Reset the panel
To reset the panel, press and hold “Cancel” for three seconds
Navigating through the menu’s
How to change a value with a VE.Net GMDSS panel
When a value is changeable you will see a little arrow in the lower left corner of the display.
If a value in the setup menu must be changed press enter. And the value will start to blink. If the value is blinking
press up and down to change it. Press enter again and the new value will be stored. If the cancel button is pressed
before the new value is stored it will return to its original value.
Devices
The GMDSS system contains two devices.
• The GMDSS monitor, which shows the state of the battery connected to the GMDSS charger.
• Panel Setup, which allows control over the panel itself
Battery Capacity
→ 200Ah
Battery Capacity
→ 200Ah
blinking
Battery Capacity
→ 200Ah
enter enter
Press ‘Enter’ to enter a device, menu or to change a value.
Press the up and down switch to change a value or navigate through a menu.
Press cancel to leave a device, menu or value.
Device
Device Menu
Device Readout Device Setup
Enter
Cancel
Setup Alarm
Enter
Cancel