User Guide

Need Help? Watch the video at www.victortech.com/High-Rise

Step 2

Place the desk surface on top of the vertical support.

1. Ensure the large side of the steel base is facing towards you before attaching the

desk surface. The two curves and arch on the steel base will be facing towards you.

2. Position the desk surface so that the height adjustment lever is on the right side.

3. The bottom of the desk surface has a hole in the center. This hole will fit directly on

the vertical support.

4. Place the desk surface on top of the vertical support.

5. The desk surface is held in place by a secure fit. In order to make the secure fit,

press your hand hard with your bodyweight directly in the center of the desk surface

(between the four Hex bolts in the Desk Surface). This may require a pounding

motion with your hand to ensure a secure fit.

**NOTE: If the desk surface is not secure on the vertical support, the gas piston may

not operate. Make sure the desk surface is secure before proceeding.