Instruction manual

7
F Floating decimal point mode; this setting specifies that all digits of the result
be shown up to a maximum of 12 digits. If the result exceeds these
capacities, excess digits to the right of the decimal point are dropped. No
rounding takes place.
0,2,3,4 Fixed decimal point mode; these settings specify the number of digits to the
right of the decimal point that are shown in the result.
2.  5/4  Rounding Switch
 Absolute round down (truncation).
5/4 This setting causes automatic round off. If the last digit of the result that will
be printed or printed/displayed upon rounding is followed by a value of 0 to
4, the digit is unchanged. If the last digit of the result that will be printed or
printed/displayed upon rounding is followed by a value of 5 to 9, the digit is
rounded up.
 Absolute round up.
3.  Switch
 Calculation without sigma.
 Calculation with Sigma. The results of multiplication or division calculations
completed by the = or % keys are automatically added to the accumulator.
The sum of these accumulations is displayed by pressing #/S key and
displayed and cleared by pressing the T key.
4. Grand Total Switch
 Calculation without Grand Total.
GT Any total taken with T key is automatically accumulated to memory. The
accumulated grand total can be recalled by pressing the MT key.
5. OFF ON PRINT Printer Selects Switch
OFF Turn Off the calculator.
ON Printer is activated only when feed key or #/S key is pressed.
PRINT Printer is activated as long as calculator is turned on.