Quick Start Guide

Compliance Information
FCC/ISEDC Compliance Notice
This device complies with Part 15 of the FCC Rules and ISEDC licence‐exempt RSS standard.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received,including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Cet appareil est conforme à la partie 15 des règles de la FCC et à la norme RSS exonérée de licence ISEDC.
L’opération est soumise aux deux conditions suivantes: (1) cet appareil ne peut pas causer d’interférences nuisibles, et (2)
cet appareil doit accepter toute interférence reçue, y compris les interférences qui peuvent causer un fonctionnement
indésirable.
Toute modification ou modification non expressément approuvée par la partie responsable de la conformité pourrait
annuler l’autorisation de l’utilisateur d’utiliser l’équipement.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
‐Reorient or relocate the receiving antenna.
‐Increase the separation between the equipment and receiver.
‐Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
‐Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
This device(X1D MARK II; model:X1D MARK II) is compliance with SAR for un-controlled FCC and ISED exposure
limits and had been tested in accordance with the measurement methods and Procedures specified in IEEE1528 and IEC
62209, this equipment should be installed and operated with minimum distance 1 cm between the radiator and your face
when close to eye operation. And Minimum distance 20 cm between the radiator and your body when hand-held
operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.